A hobbyist found that a failing NanoLeaf modular light controller can be replaced with a simple ESP32 board, since NanoLeaf publishes its firmware and the panels communicate positions and orientation over a single data bus. With slight modification, the ESP32 runs the firmware and can also report status over the network, allowing control from other lighting software. The project and alternative fixes are discussed in a related Reddit thread, and it follows earlier community projects building NanoLeaf-inspired panels from scratch.
Nguồn: https://hackaday.com/2026/09/22/esp32-replacement-for-lighting-display-controller. 8 Sync News chỉ tóm tắt và dẫn link; bản quyền nội dung thuộc tác giả và nguồn gốc.
Đọc tin ở đây, luyện code, học theo lộ trình và luyện IELTS trên các sản phẩm anh em — tất cả kết nối với nhau trong hệ sinh thái 8 Sync.
Cổng chính của hệ sinh thái: giới thiệu sản phẩm, blog và bảng giá trọn bộ.
Khám pháHọc theo lộ trình rõ từng chặng: video, quiz chấm tự động, certificate và mentor đang làm nghề.
Xem lộ trình1.000 bài DSA, đề tiếng Việt, chấm tự động 7 ngôn ngữ — nhiều bài FREE, chạy ngay trên trình duyệt.
Luyện miễn phíChấm bốn kỹ năng IELTS bằng AI, phản hồi chi tiết theo rubric.
Dùng thử miễn phíAI IDE 22 MB cho dev Việt.
Tải miễn phíBộ nhớ tổ chức cho AI agent.
Khám pháAI trực Fanpage, tự sàng lọc lead.
Dùng thửA maker transforms a Raspberry Pi gaming handheld into a DIY cyberdeck with GPS, Wi-Fi, a camera, and an ESP32. See the community build.
It was a little too good at what it did, though.
All of your fave tunes, all of the time.
An $8 Ox64 RISC-V single-board computer can run full Linux, not a stripped-down MMU-less kernel. It has three different RISC-V cores, but ethernet, wifi and SD card don't work yet. Flashing it is painful: it must be programmed over UART, not USB, and DevCube crashes on Wayland so you need Xorg. A CH340G USB-UART dongle failed the handshake, so the author used an RP2040 (Adafruit KB2040) running picoprobe as a serial bridge, then had to modify bflb-mcu-tool's uart interface file to strip DTR/RTS handling before it would flash the M0 core.
What I run on my $10 USD OpenStick homelab
A DIY camera built around a Raspberry Pi 5 features a custom enclosure, interchangeable lenses, open-source software, and 4K support.
My Nest only knew the hallway, and a $40 sensor proved the hallway was the wrong room
As businesses put more agents to work, AI factories need CPUs that can execute those steps quickly and support many agents at once, all within the limits of available power.
Đang tải bình luận…