The 8-pin CPU power cable on modern motherboards is actually two 4-pin cables joined together, a leftover from the Pentium 4 era. The ATX12V spec added a dedicated 4-pin +12V CPU connector when Pentium 4 chips needed more power, separating CPU power from the main connector's 5V rail. The ATX12V 2.0 revision in 2003 evolved this into the 4+4 pin standard, borrowed from server motherboards to handle multicore power needs. This EPS12V design became official with the 2.2 revision around 2005 and still appears unchanged in the modern ATX 3.0 standard. The split let old systems use one 4-pin cable while new systems used both, avoiding a disruptive switch to a rigid 8-pin connector. The 8-pin CPU and GPU cables look alike but have different pinouts, so swapping them can damage hardware.
Nguồn: https://www.xda-developers.com/cpu-power-cable-split-pins-pentium-4-era-leftover. 8 Sync News chỉ tóm tắt và dẫn link; bản quyền nội dung thuộc tác giả và nguồn gốc.
Đọc tin ở đây, luyện code, học theo lộ trình và luyện IELTS trên các sản phẩm anh em — tất cả kết nối với nhau trong hệ sinh thái 8 Sync.
Cổng chính của hệ sinh thái: giới thiệu sản phẩm, blog và bảng giá trọn bộ.
Khám pháHọc theo lộ trình rõ từng chặng: video, quiz chấm tự động, certificate và mentor đang làm nghề.
Xem lộ trình1.000 bài DSA, đề tiếng Việt, chấm tự động 7 ngôn ngữ — nhiều bài FREE, chạy ngay trên trình duyệt.
Luyện miễn phíChấm bốn kỹ năng IELTS bằng AI, phản hồi chi tiết theo rubric.
Dùng thử miễn phíAI IDE 22 MB cho dev Việt.
Tải miễn phíBộ nhớ tổ chức cho AI agent.
Khám pháAI trực Fanpage, tự sàng lọc lead.
Dùng thửTurns out, it isn't just about lowering temperatures.
A Fluke Model 407 high-voltage power supply gets rescued from the scrap heap and diagnosed on video. Mr Carlson powers it up safely using an isolated transformer and a current-limited variac, avoiding the risk of full power on old components. The vacuum-tube-and-circuit-board unit shows no visible damage but its output misbehaves. Using the original schematics, he traces the fault to a single faulty capacitor in the feedback loop that keeps output voltage constant.
Like some of you, we have several kitchen appliances with integrated digital timers.
It was a little too good at what it did, though.
All of your fave tunes, all of the time.
What I run on my $10 USD OpenStick homelab
An $8 Ox64 RISC-V single-board computer can run full Linux, not a stripped-down MMU-less kernel. It has three different RISC-V cores, but ethernet, wifi and SD card don't work yet. Flashing it is painful: it must be programmed over UART, not USB, and DevCube crashes on Wayland so you need Xorg. A CH340G USB-UART dongle failed the handshake, so the author used an RP2040 (Adafruit KB2040) running picoprobe as a serial bridge, then had to modify bflb-mcu-tool's uart interface file to strip DTR/RTS handling before it would flash the M0 core.
Thay vì mua thiết bị dash cam chuyên dụng, tác giả nhận ra chiếc điện thoại cũ hoàn toàn có thể thay thế với chi phí bằng không. Nguyên nhân kỹ thuật là nhờ vào các tính năng như Continuous Video Recording (CVR) và ứng dụng như DailyRoads Voyager, điện thoại cũ có thể ghi hình liên tục mà không cần thiết bị bổ sung. Hệ quả là tiết kiệm đáng kể chi phí (thường từ 50 đến 200 USD cho thiết bị chuyên dụng) và vẫn đảm bảo ghi lại video chất lượng tốt trong điều kiện lái xe. Điều đáng học hỏi là việc tái sử dụng thiết bị điện tử hiện có vừa kinh tế vừa thân thiện với môi trường, tránh lãng phí tài nguyên.
Điện thoại cũ của bạn có thể thay thế camera hành trình một cách hiệu quả và tiết kiệm chi phí.
Đang tải bình luận…